STEERING PAD SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering pad switch assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

PROCEDURE


  1. REMOVE HORN BUTTON ASSEMBLY

    Click here

  2. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. Disconnect the steering pad switch connector from the spiral cable with sensor sub-assembly.

    2. B0070AF

      Remove the 2 screws.

    3. Disengage the 4 claws and 3 pins to remove the steering pad switch assembly.