STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not remove/install the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL NO. 1 SWITCH WIRE (w/ Shift Paddle Switch)

    Click here

  2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (w/ Shift Paddle Switch)

    Click here

  3. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  6. INSTALL STEERING WHEEL ASSEMBLY


    1. B00719PC01
      *a Matchmark

      Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

    2. Using a 10 mm hexagon socket wrench, install the steering wheel assembly set bolt.

      Torque:
      62 N*m  { 632 kgf*cm, 46 ft.*lbf }

    3. Connect each connector to the spiral cable with sensor sub-assembly.

  7. CHECK STEERING WHEEL CENTER POINT

  8. INSTALL HORN BUTTON ASSEMBLY

    Click here