ELECTRIC PARKING BRAKE ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Click here

  2. RELEASE PARKING BRAKE


    1. Move the shift lever to P.

    2. Turn the ignition switch to ON.

    3. Operate the electric parking brake switch assembly to release the parking brake.

      Tech Tips

      If the parking brake cannot be released:

      Click here

    4. Turn the ignition switch off.

  3. REMOVE REAR WHEEL

    Click here

  4. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY


    1. B0070DS

      Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

      Note


      • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.

      • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.

  5. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY


    1. B006ZTK

      Using a 5 mm hexagon socket wrench, remove the 2 bolts and parking brake actuator assembly from the rear disc brake cylinder assembly.

      Note


      • Check for brake fluid leaks on the back side of the rear disc brake cylinder assembly.

      • If there are any brake fluid leaks, replace the rear disc brake cylinder assembly.

    2. Remove the O-ring from the rear disc brake cylinder assembly.