REAR BRAKE REMOVAL

CAUTION / NOTICE / HINT

Note


  • Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.

  • After replacing the rear disc brake pads, always perform a road test to check the braking performance and check for vibrations.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE REAR WHEEL

    Click here

  3. PERFORM REAR BRAKE PAD REPLACEMENT MODE

    Click here

  4. DRAIN BRAKE FLUID

    Note

    If brake fluid leaks onto any painted surface, immediately wash it off.

  5. SEPARATE REAR FLEXIBLE HOSE


    1. B004LDJ

      Remove the union bolt and gasket, and disconnect the rear flexible hose from the rear disc brake cylinder assembly.

  6. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

    Click here

  7. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY

    Click here

  8. REMOVE REAR DISC BRAKE CYLINDER ASSEMBLY


    1. B004MU8C02
      *a Turn
      *b Hold

      Hold the 2 rear disc brake cylinder slide pins and remove the 2 bolts and rear disc brake cylinder assembly.

  9. REMOVE REAR DISC BRAKE PAD


    1. B004LRP

      Remove the 2 rear disc brake pads from the rear disc brake cylinder mounting.

  10. REMOVE REAR DISC BRAKE ANTI-SQUEAL SHIM KIT

    Click here

  11. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE


    1. B004HK0

      Remove the 4 rear disc brake pad support plates from the rear disc brake cylinder mounting.

      Note

      Each rear disc brake pad support plate has a different shape. Be sure to put an identification mark on each rear disc brake pad support plate so that it can be reinstalled to its original position.

  12. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN


    1. B004MYDC02
      *1 Rear No. 1 Disc Brake Cylinder Slide Pin
      *2 Rear No. 2 Disc Brake Cylinder Slide Pin

      Remove the rear No. 1 disc brake cylinder slide pin and rear No. 2 disc brake cylinder slide pin from the rear disc brake cylinder mounting.

    2. B004NXEC01
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, remove the rear disc brake cylinder slide bushing from the rear No. 2 disc brake cylinder slide pin.

      Note

      Do not damage the rear No. 2 disc brake cylinder slide pin.

  13. REMOVE REAR DISC BRAKE BUSHING DUST BOOT


    1. B004I9V

      Remove the 2 rear disc brake bushing dust boots from the rear disc brake cylinder mounting.

  14. REMOVE REAR DISC BRAKE CYLINDER MOUNTING


    1. B004JTU

      Remove the 2 bolts and rear disc brake cylinder mounting.

  15. REMOVE REAR DISC


    1. B004N78C02
      *a Matchmark

      Put matchmarks on the rear disc and rear axle hub and bearing assembly.

    2. Remove the rear disc.