VACUUM PUMP(for A25A-FKS) INSTALLATION

CAUTION / NOTICE / HINT

Note

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

PROCEDURE

INSTALL VACUUM PUMP ASSEMBLY
1. When reusing the vacuum pump assembly:
  1. Install a new No. 1 vacuum pump O-ring to the vacuum pump assembly.
2. *a Coupling Teeth
  
  *b Groove
  
  Install the vacuum pump assembly so that the coupling teeth of the vacuum pump assembly and groove of the camshaft are engaged.
  Note
  
  Ensure that the vacuum pump assembly is installed securely.
  
  Be careful not to pinch the No. 1 vacuum pump O-ring.
3. Using an 8 mm socket wrench, install the vacuum pump assembly with the 3 bolts.
  
  Torque:
  
  10 N*m { 102 kgf*cm, 7 ft.*lbf }
  
  Note
  
  After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.
INSTALL ENGINE WIRE
1. Engage the 2 clamps to install the engine wire.
CONNECT NO. 1 VACUUM HOSE CONNECTOR
1. Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.
  Note
  - Check that there is no foreign matter on the connecting parts.
  - After connecting the No. 1 vacuum hose connector, check that the vacuum pump assembly and No. 1 vacuum hose connector are securely connected by pulling on them.
INSPECT VACUUM PUMP OPERATION

Click here

*a	Coupling Teeth
*b	Groove