VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1288

DTC Code DTC Name
C1288 Error in Matching of ECUs

DESCRIPTION

The skid control ECU (brake actuator assembly) stores this DTC when the previously learned values in the VSC system and engine information sent from the ECM are inconsistent, or when the learning has not completed after the skid control ECU (brake actuator assembly) is replaced with a new one.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1288 Error in Matching of ECUs ECM does not match. ECM

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication system DTCs are output.

      Click here

      Result
      Result Proceed to
      DTCs are not output A
      DTCs are output B

    B

    INSPECT CAN COMMUNICATION SYSTEM Click here

    A

  2. PERFORM SYSTEM VARIANT LEARNING


    1. Perform system variant learning.

      Click here

      Tech Tips


      • System variant learning is automatically performed immediately after Test Mode is entered.

      • If learning has not yet been performed, the slip indicator light will remain on and DTC C1288 will be stored.

      • If system variant learning is not successful, the warning lights will not blink in the Test Mode pattern and DTC C1288 will not be cleared.

      Result
      Proceed to
      NEXT

    NEXT

  3. RECONFIRM DTC


    1. Clear the DTCs.


      Chassis > ABS/VSC/TRC > Clear DTCs

    2. Turn the ignition switch off.

    3. Start the engine.

    4. Check if the same DTC is output.


      Chassis > ABS/VSC/TRC > Trouble Codes
      Result
      Result Proceed to
      C1288 is not output A
      C1288 is output B

    A

    END

    B

    REPLACE ECM for 2AR-FE: Click here
    REPLACE ECM for A25A-FKS: Click here
    REPLACE ECM for 2GR-FKS: Click here