VEHICLE STABILITY CONTROL SYSTEM DTC CHECK / CLEAR

DTC CHECK/CLEAR (When Using GTS)

1. Check for DTCs.

   
   

   1. Turn the ignition switch off.

   2. Connect the GTS to the DLC3.

   3. Turn the ignition switch to ON.

   4. Turn the GTS on.

   5. Read the DTCs following the prompts on the GTS. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

      
      Chassis > ABS/VSC/TRC > Trouble Codes

   6. Check the details of the DTCs.

      Click here

      Note

      The vehicle stability control system outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the vehicle stability control system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

      System	Proceed to
      Electric Parking Brake System	Click here

2. Clear the DTCs.

   
   

   1. Turn the ignition switch off.

   2. Connect the GTS to the DLC3.

   3. Turn the ignition switch to ON.

   4. Turn the GTS on.

   5. Operate the GTS to clear the codes. Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.

      
      Chassis > ABS/VSC/TRC > Clear DTCs

   6. Press the DTC clear button.

END OF DTC CHECK/CLEAR

1. Turn the ignition switch to ON.

2. Check that the ABS warning, slip indicator and brake hold operated indicator* lights go off within approximately 3 seconds of turning the ignition switch to ON.

   *: The brake hold switch (electric parking brake switch assembly) is pressed under the following vehicle conditions.

   
   

   • Vehicle Conditions:

   
   

   1. The driver door is closed.

   2. The driver seat belt is fastened.