TIRE PRESSURE WARNING RECEIVER INSTALLATION

PROCEDURE

1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER

   Note

   
   

   • Do not drop, strike or otherwise subject the tire pressure warning ECU and receiver to impact.

   • If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.

   
   
   1. 

      *A	for Type A
      *B	for Type B

      Connect the connector.

   2. Engage the 2 guides and install the tire pressure warning ECU and receiver with the bolt.

      Torque:

      for Type A

      8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

      for Type B

      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      There are three types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

2. INSTALL INNER ROOF SIDE GARNISH RH

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

3. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Fold Down Seat Type)

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fold Down Seat Type)

   Click here

5. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type)

   Click here

6. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

   Click here

7. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Fold Down Seat Type)

   Click here

8. INSTALL REAR SIDE SEATBACK ASSEMBLY RH (for Reclining Seat Type)

   Tech Tips

   Use the same procedure as for the LH side.

   Click here

9. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Reclining Seat Type)

   Click here

10. INSTALL REAR SEATBACK ASSEMBLY RH (for Reclining Seat Type)

    Click here

11. INSTALL REAR SEATBACK COVER (for Reclining Seat Type)

    Click here

12. INSTALL REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type)

    Click here

13. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type)

    Click here

14. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Reclining Seat Type)

    Click here

15. INSTALL REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type)

    Click here

16. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for Fixed Seat Type)

    Click here

17. INSTALL REAR SEAT ASSEMBLY (for Fixed Seat Type)

    Click here

18. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag)

    Click here

19. REGISTER TRANSMITTER ID

    Click here

20. INSPECT TIRE PRESSURE WARNING SYSTEM

    Click here

21. PERFORM INITIALIZATION

    Click here

22. PERFORM DIAGNOSTIC SYSTEM CHECK (w/ Rear Seat Side Airbag)

    Click here

23. INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag)

    Click here