REAR STABILIZER BAR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear stabilizer bar removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here for 2AR-FE

Click here for A25A-FKS

Click here for 2GR-FKS

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B00719S

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. REMOVE NO. 2 FLOOR UNDER COVER (w/ Cover)


    1. B0070C6N01

      Remove the 2 bolts and clip (A).

    2. Disengage the 2 grommets (B) and 2 clips (C) to remove the No. 2 floor under cover.

  3. REMOVE NO. 1 FLOOR UNDER COVER (w/ Cover)


    1. B006X5ZN01

      Remove the 2 bolts and clip (A).

    2. Disengage the 2 grommets (B) and 2 clips (C) to remove the No. 1 floor under cover.

  4. REMOVE CENTER EXHAUST PIPE ASSEMBLY

    for 2AR-FE: Click here

    for A25A-FKS: Click here

    for 2GR-FKS: Click here

  5. REMOVE REAR STABILIZER LINK ASSEMBLY LH


    1. B006XG5N02

      Loosen the nut (A) of the rear stabilizer link assembly LH.

      Tech Tips

      If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

    2. Loosen the nut (B) of the rear stabilizer link assembly LH.

      Note

      Because the bolt has its own stopper, do not turn the bolt. Loosen the nut with the bolt secured.

    3. B0070WDC03
      *a Wooden Block
      *b Jack

      Using a jack and a wooden block, support the rear No. 2 suspension arm assembly.

      Note


      • When jacking up the rear No. 2 suspension arm assembly, be sure to jack it up slowly.

      • Make sure to perform this operation with the vehicle kept as low as possible.

    4. B006XG5

      Remove the bolt, 2 nuts and rear stabilizer link assembly LH.

  6. REMOVE REAR STABILIZER LINK ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  7. REMOVE REAR STABILIZER BAR


    1. B006X76

      Remove the 4 bolts, rear stabilizer bar, 2 rear No. 1 stabilizer bar brackets and 2 rear stabilizer bushings from the rear suspension member sub-assembly.

  8. REMOVE REAR NO. 1 STABILIZER BAR BRACKET


    1. B006YYL

      Remove the 2 rear No. 1 stabilizer bar brackets from the 2 rear stabilizer bushings.

  9. REMOVE REAR STABILIZER BUSHING


    1. B0070I8

      Remove the 2 rear stabilizer bushings from the rear stabilizer bar.