REAR LOWER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY


    1. Temporarily install the rear No. 1 suspension arm assembly to the rear axle carrier sub-assembly and rear suspension member sub-assembly with the 2 bolts and 2 nuts.

      Note


      • Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

      • Insert the bolt with the threaded end facing the rear of the vehicle.

  2. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Temporarily install the rear No. 2 suspension arm assembly to the rear suspension member sub-assembly with the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and nut.

      Note


      • Insert the rear suspension toe adjust cam sub-assembly from the rear of the vehicle.

      • When tightening the nut, keep the rear suspension toe adjust cam sub-assembly from rotating.

  3. INSTALL REAR LOWER COIL SPRING INSULATOR

    Click here

  4. INSTALL REAR COIL SPRING

    Click here

  5. STABILIZE SUSPENSION

    Click here

  6. INSTALL REAR STABILIZER LINK ASSEMBLY

    Click here

  7. INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY


    1. B0070WB

      Install the rear No. 1 suspension arm assembly with the 2 bolts.

      Torque:
      73 N*m  { 744 kgf*cm, 54 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  8. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. B006XW8

      Install the rear No. 2 suspension arm assembly (rear axle carrier sub-assembly side) with the bolt.

      Torque:
      73 N*m  { 744 kgf*cm, 54 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  9. INSTALL NO. 1 FLOOR UNDER COVER (w/ Cover)


    1. for RH Side:

      Click here

  10. INSTALL NO. 2 FLOOR UNDER COVER (w/ Cover)


    1. for LH Side:

      Click here

  11. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (for LH Side)

    Click here

  12. INSTALL REAR WHEEL

    Click here

  13. INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. Lower the vehicle to the ground.

    2. Bounce the vehicle up and down at the corners to stabilize the rear suspension.

    3. B0071D9C01
      *a Matchmark

      Align the matchmarks on the No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear suspension member sub-assembly.

    4. Fully tighten the nut.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

      Note


      • Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

      • Make sure that the vehicle is unloaded when fully tightening the nut.

  14. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  15. PERFORM INITIALIZATION

    Parking assist monitor system

    Click here for Initialization

    Click here for Calibration
    Lighting system (EXT)

    Click here