Click here

REAR LOWER ARM REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension arm assembly removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear wheel alignment adjustment Perform system variant learning and acceleration sensor zero point calibration.

  • VSC disabled or malfunctioning

  • DTCs are output

  • Slip indicator light illuminated

  • ABS warning light illuminated

Click here

Suspension, tires

(The vehicle height changes because of suspension or tire replacement.)

 Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click herefor Initialization

Click herefor Calibration
Perform headlight ECU sub-assembly LH initialization Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)

Click here
Rear height control sensor sub-assembly LH Perform headlight ECU sub-assembly LH initialization Lighting System (EXT) (w/ Automatic Headlight Beam Level Control System)

Click here
Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE REAR WHEEL

    Click here

  2. Click here

    REMOVE NO. 2 FLOOR UNDER COVER (w/ Cover)


    1. for LH Side:

      Click here

  3. Click here

    REMOVE NO. 1 FLOOR UNDER COVER (w/ Cover)


    1. for RH Side:

      Click here

  4. Click here

    REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Height Control Sensor)


    1. for LH Side:

      Click here

  5. Click here

    REMOVE REAR STABILIZER LINK ASSEMBLY

    Click here

  6. Click here

    REMOVE REAR COIL SPRING

    Click here

  7. Click here

    REMOVE REAR LOWER COIL SPRING INSULATOR

    Click here

  8. Click here

    REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY


    1. B006XOT

      Remove the nut, No. 2 camber adjust cam, rear suspension toe adjust cam sub-assembly and rear No. 2 suspension arm assembly.

      Note:

      Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

  9. Click here

    REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY


    1. B00719W

      Remove the 2 bolts, 2 nuts and rear No. 1 suspension arm assembly from the rear axle carrier sub-assembly and rear suspension member sub-assembly.

      Note:

      Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut secured.