REAR AXLE HUB REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR WHEEL

    Click here

  2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY


    1. B0071IB

      Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

      Note


      • Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this step.

      • Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.

    2. B004NIWC02
      *a Protective Tape

      Using a screwdriver with its tip wrapped with protective tape, disconnect the No. 2 parking brake wire assembly connector from the rear axle hub and bearing assembly.

      Note

      Be careful not to damage the rear axle hub and bearing assembly or connector cover.

  3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  4. REMOVE REAR DISC

    Click here

  5. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY


    1. B004KPF

      Remove the 4 bolts, rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly from the rear axle carrier sub-assembly.