TRANSMISSION CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on

Click here

Perform code registration (Immobiliser system)

  • Wireless door lock control system

  • Smart Entry and Start System (for Entry Function)

  • Smart Entry and Start System (for Start Function)

  • Steering lock function

 See Service Bulletin for the registration method.
ECM (If possible, read the transaxle compensation code from the previous ECM) Possible

Perform the following procedures in the order shown:


  1. Reset Memory

  2. Transfer transaxle compensation code

  3. Perform road test to allow ECM to learn

  • Large shift shock

  • The deterioration of fuel efficiency

Click here for U760E Initialization

Click here for U760E Registration
Impossible

Perform the following procedures in the order shown:


  1. Reset Memory

  2. Reset transaxle compensation code

  3. Perform road test to allow ECM to learn
Replacement of ECM*1 Perform code registration (Immobiliser function)

  • Wireless door lock control system

  • Smart Entry and Start System (for Entry Function)

  • Smart Entry and Start System (for Start Function)

  • Steering lock function

 See Service Bulletin for the registration method.
Replacement of ECM*2 Perform code registration (Immobiliser system)

  • Wireless door lock control system

  • Engine start

 See Service Bulletin for the registration method.
*1: w/ Smart Entry and Start System
*2: w/o Smart Entry and Start System

PROCEDURE


  1. REMOVE BATTERY

    Click here

  2. REMOVE ECM

    Click here

  3. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  4. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  5. REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR


    1. B006Z65

      Remove the 2 nuts and front lower No. 1 floor heat insulator from the vehicle body.

  6. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

    Click here

  7. REMOVE NO. 1 CONSOLE BOX DUCT


    1. B007041

      Remove the No. 1 console box duct.

  8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. B006YRS

      Remove the nut and disconnect the transmission control cable assembly from the transmission control shaft lever.

    2. B006X5H

      Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    3. B006Y28

      Remove the 2 nuts and disconnect the transmission control cable assembly from the vehicle body.

    4. B006YVK

      Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.