STARTER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the starter assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. REMOVE BATTERY

    Click here

  3. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  4. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  5. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

    Click here

  7. REMOVE ECM

    Click here

  8. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  9. REMOVE STARTER ASSEMBLY


    1. B006XQ2

      Disconnect the starter assembly connector.

    2. Open the terminal cap.

    3. Remove the nut and disconnect the engine wire from the terminal 30.

    4. B006Z6W

      Remove the 2 bolts and starter assembly.