OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. B0071JKC07
      *a Adhesive 1344
      *b Oil Inlet Port

      Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note


      • Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.

      • Install the engine oil pressure switch assembly within 3 minutes of applying adhesive.

    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installation.

    3. Connect the engine oil pressure switch assembly connector.

    4. Engage the clamp to connect the wire harness protector.

  2. ADD ENGINE OIL

    Click here

  3. CHECK ENGINE OIL LEVEL

    Click here

  4. INSPECT FOR OIL LEAK

    Click here

  5. INSTALL FRONT FENDER APRON SEAL RH

    Click here