OIL PRESSURE SWITCH INSPECTION

PROCEDURE


  1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. B0071R5C01
      *1 Wire Harness Protector

      Disengage the clamp to disconnect the wire harness protector.

    2. Disconnect the engine oil pressure switch assembly connector.

    3. Start the engine.

    4. B006XLOC03
      *a Engine Oil Pressure Switch Assembly Body

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - Engine oil pressure switch assembly body Idling 10 kΩ or higher
      Engine stopped Below 1 Ω

      If the result is not as specified, replace the engine oil pressure switch assembly.

    5. Connect the engine oil pressure switch assembly connector.

    6. Connect the wire harness protector.