THERMOSTAT INSTALLATION

CAUTION / NOTICE / HINT

Note

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY


    1. Install a new gasket to the water inlet with thermostat sub-assembly.

      Tech Tips

      Be sure to clean the contact surfaces.

    2. Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.

    4. Connect the water inlet with thermostat sub-assembly connector.

  2. CONNECT NO. 2 RADIATOR HOSE

    Click here

  3. INSTALL GENERATOR ASSEMBLY

    Click here

  4. ADD ENGINE COOLANT

    Click here

  5. INSPECT FOR COOLANT LEAK

    Click here