WATER PUMP REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine water pump assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE GENERATOR ASSEMBLY

    Click here

  3. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

    Click here

  4. REMOVE ENGINE WATER PUMP ASSEMBLY


    1. B006WVV

      Remove the 7 bolts, engine water pump assembly and water pump gasket.