INTAKE AIR CONTROL VALVE ACTUATOR(for TCV) INSTALLATION

PROCEDURE


  1. INSTALL INTAKE AIR CONTROL VALVE ACTUATOR (for TCV)

    Note


    • B0070NY

      Make sure that foreign matter, such as water, oil, sand or iron particles, does not enter the gear chamber or intake air control valve actuator (for TCV) at the locations marked by the circles in the illustration.

    • B0070ZJ

      Do not loosen or remove the bolt and 2 nuts shown in the illustration.


    1. B004MCCC02
      *a Tumble Control Valves (TCV) Closed

      Check that the 4 tumble control valves (TCV) are closed.

      Tech Tips

      If the 4 tumble control valves (TCV) are not closed, close them by hand.

    2. B004IV4C04
      *a Tumble Control Valves (TCV) Closed
      *b Stopper

      Check that the gear of the 4 tumble control valves (TCV) is in the position shown in the illustration.

      Tech Tips

      Turn the gear clockwise until it contacts the stopper.

    3. Install a new gasket to the intake air control valve actuator (for TCV).

    4. Install the intake air control valve actuator (for TCV) to the intake manifold with the 2 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note


      • If excessive rotational force is applied to the gear of the 4 tumble control valves (TCV), the 4 tumble control valves (TCV) and intake air control valve actuator (for TCV) may be damaged.

      • After installing the intake air control valve actuator (for TCV), make sure that the 4 tumble control valves (TCV) are not protruding. If the 4 tumble control valves (TCV) are protruding, remove and reinstall the intake air control valve actuator (for TCV).

  2. INSTALL INTAKE MANIFOLD

    Click here