FUEL PUMP REASSEMBLY

PROCEDURE


  1. INSTALL FUEL PUMP

    Tech Tips

    Perform "Inspection After Repair" after replacing the fuel pump.

    Click here


    1. B007029C04
      *1 O-ring
      *2 Fuel Pump Spacer

      Apply gasoline to a new O-ring. Then install the O-ring and fuel pump spacer to the fuel pump.

    2. B004JK1

      Install the fuel pump to the suction filter.

    3. B004KJP

      Engage the 3 claws to install the fuel pump to the fuel filter.

      Note


      • Make sure that the O-ring is not cut or pinched during the installation.

      • Securely engage the claws.

      • Do not remove the suction filter from the fuel pump.

    4. B004OAZ

      Connect the fuel pump harness connector to install the fuel pump harness to the fuel pump.

    5. B004K9C

      Engage the claw to connect the fuel pump harness to the fuel pump.

      Note


      • Securely engage the claw.

      • Make sure that there is no foreign matter between the fuel pump and the ground terminal of the fuel pump harness.

      • Make sure that the ground terminal of the fuel pump harness is securely connected to the fuel pump body.

    6. Check the connection state of the fuel pump harness.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Fuel pump body - Ground terminal of the fuel pump harness Always Below 1 Ω

        If the result is not as specified, reconnect the fuel pump harness to the fuel pump so that the ground terminal of the fuel pump harness is securely connected to the fuel pump body.

    7. Engage the 2 claws to install the fuel filter to the fuel sub-tank.

      Note


      • Do not apply excessive force to the tube or No. 1 fuel suction support.

      • Securely engage the claws.

    8. B004KYB

      Engage the clamp and claw, and connect the fuel pump filter hose while aligning it with the installation position of the fuel sub-tank.

      Note

      Securely engage the clamp and claw.

    9. Engage the clamp to connect the fuel pump harness to the fuel suction plate sub-assembly.

    10. Connect the 2 fuel pump harness connectors.

    11. Install the harness protector to the fuel pump harness.

  2. INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here