CANISTER(w/o Canister Pump Module) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during canister (fuel suction plate sub-assembly) removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Replacement of fuel pump Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY

    Click here

  3. REMOVE FUEL PUMP

    Click here

  4. REMOVE FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

    Click here

  5. REMOVE FUEL MAIN VALVE ASSEMBLY (for High Pressure)

    Click here

  6. REMOVE NO. 1 FUEL SUCTION SUPPORT

    Click here