FUEL PUMP ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pump ECU removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:


  • Wear protective gloves. Sharp areas on the parts may injure your hands.

  • B0071NY

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • B006XLM

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

  • If an airbag deploys for any reason, it may cause a serious injury.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    Click here

  4. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  5. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  6. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    Click here

  9. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH

    Tech Tips

    Use the same procedure as for the LH side.

  10. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  11. REMOVE CENTER STOP LIGHT SET

    Click here

  12. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY LH

    Click here

  13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  14. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  15. REMOVE INNER ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  16. REMOVE REAR SEAT SHOULDER BELT HOLE COVER

    Click here

  17. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


  18. REMOVE ROOM PARTITION BOARD LH

    Click here

  19. REMOVE FUEL PUMP CONTROL ECU


    1. B0070KH

      Disconnect the 2 fuel pump control ECU connectors.

    2. B0071M6

      Remove the nut and fuel pump control ECU from the vehicle body.

      Note

      Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.

  20. REMOVE FUEL PUMP CONTROL ECU BRACKET


    1. B00713B

      Remove the 2 bolts and fuel pump control ECU bracket from the fuel pump control ECU.