FUEL MAIN VALVE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel main valve assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Replacement of fuel pump Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

CAUTION:


  • B006ZQO

    Never perform work on fuel system components near any possible ignition sources.

  • Vaporized fuel could ignite, resulting in a serious accident.

  • B006XC9

    Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

  • Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

PROCEDURE


  1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

    Click here

  2. REMOVE FUEL SENDER GAUGE ASSEMBLY

    Click here

  3. REMOVE FUEL PUMP

    Click here

  4. REMOVE FUEL MAIN VALVE ASSEMBLY


    1. B006ZOC

      Remove the fuel main valve assembly (for Low Pressure).


      1. Remove the clip from the fuel filter.

      2. B006Z5NC01
        *a Protective Tape

        Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel filter.

        Note


        • Pull out the fuel main valve assembly carefully because the O-rings are firmly installed between the fuel main valve assembly and fuel filter.

        • Do not damage the fuel filter.

      3. B006ZUFC10
        *1 O-ring

        Remove the 2 O-rings from the fuel main valve assembly.

    2. B006Z8W

      Remove the fuel main valve assembly (for High Pressure).


      1. Remove the clip from the fuel filter.

      2. B0071FWC01
        *a Protective Tape

        Using a screwdriver with its tip wrapped with protective tape, remove the fuel main valve assembly from the fuel filter.

        Note


        • Pull out the fuel main valve assembly carefully because the O-rings are firmly installed between the fuel main valve assembly and fuel filter.

        • Do not damage the fuel filter.

      3. B006ZUFC10
        *1 O-ring

        Remove the 2 O-rings from the fuel main valve assembly.