FUEL PRESSURE PULSATION DAMPER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel pressure pulsation damper assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:


  • B006ZQO

    Never perform work on fuel system components near any possible ignition sources.

  • Vaporized fuel could ignite, resulting in a serious accident.


  • B006XC9

    Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.

  • Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  5. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  6. DISCONNECT FUEL TUBE SUB-ASSEMBLY


    1. B0070DFC01
      *a Claw

      Disengage the 2 claws to remove the No. 2 fuel pipe clamp.

    2. B006YNL

      Disconnect the fuel tube sub-assembly from the fuel delivery pipe.

      SST
      09268-21011

    3. Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose clamp.

  7. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    1. B0071IV

      Remove the 2 bolts and fuel pressure pulsation damper assembly from the fuel delivery pipe.

    2. B0070FQ

      Remove the O-ring from the fuel pressure pulsation damper assembly.