FUEL FILTER(w/o Canister Pump Module) REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fuel filter removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Battery terminal is disconnected/reconnected	Perform steering sensor zero point calibration	Lane departure alert system (w/ Steering Control)	Click here
	Perform steering sensor zero point calibration	Pre-collision system	Click here
	Memorize steering angle neutral point	Parking assist monitor system	Click here
Replacement of fuel pump	Inspection after repair	Poor idle, etc. Engine start function, etc.	Click here

CAUTION:

Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.

Do not perform work on fuel system components without first disconnecting the cable from the negative (-) battery terminal.
Sparks could cause vaporized fuel to ignite, resulting in a serious accident.

PROCEDURE

REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here
REMOVE FUEL SENDER GAUGE ASSEMBLY

Click here
REMOVE FUEL PUMP

Click here
REMOVE FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

Click here
REMOVE FUEL MAIN VALVE ASSEMBLY (for High Pressure)

Click here
REMOVE NO. 1 FUEL SUCTION SUPPORT
1. Remove the No. 1 fuel suction support from the fuel filter.
INSTALL NO. 1 FUEL SUCTION SUPPORT
1. Install the No. 1 fuel suction support to the fuel filter.
INSTALL FUEL MAIN VALVE ASSEMBLY (for High Pressure)

Click here
INSTALL FUEL MAIN VALVE ASSEMBLY (for Low Pressure)

Click here
INSTALL FUEL PUMP

Click here
INSTALL FUEL SENDER GAUGE ASSEMBLY

Click here
INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

Click here