FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. B004MZDC01
      *a Oil Seal Protrusion Height

      Apply MP grease to the lip of a new timing chain case oil seal.

    2. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.

      SST
      09316-60011   ( 09316-00011 )
      Oil Seal Protrusion Height
      0 to 1.0 mm (0 to 0.0394 in.)

      Note


      • Keep the lip free from foreign matter.

      • Do not tap in the timing chain case oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the crankshaft pulley.

    2. B004LVWC01
      *a Hold
      B006Z38 Turn

      Using SST to hold the crankshaft pulley in place, tighten the crankshaft pulley set bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

  3. INSTALL V-RIBBED BELT

    Click here

  4. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

    Click here