FRONT CRANKSHAFT OIL SEAL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front crankshaft oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Replacement of ECM Vehicle Identification Number (VIN) registration MIL comes on

w/ Canister Pump Module: Click here

w/o Canister Pump Module: Click here

Perform code registration (Immobiliser system) Engine start function See Service Bulletin for the registration method.

  • Gas leak from exhaust system is repaired

  • Replacement of air fuel ratio sensor

 Inspection After Repair

  • Poor idle, etc.

  • Engine start function, etc.

w/ Canister Pump Module: Click here

w/o Canister Pump Module: Click here

Replacement of automatic transaxle assembly

  1. Reset memory

  2. Input transaxle compensation code into ECM

  3. Perform road test to allow ECM to learn

  • Large shift shock

  • Deterioration of fuel efficiency

Click here for UB80E Initialization

Click here for UB80E Registration

Replacement of ECM

(If possible, read the transaxle compensation code from the previous ECM)

  1. Reset memory*1

  2. Transfer transaxle compensation code

  3. Perform road test to allow ECM to learn

Replacement of ECM

(If impossible, read the transaxle compensation code from the previous ECM)

  1. Reset memory*1

  2. Reset transaxle compensation code

  3. Perform road test to allow ECM to learn
Replacement of ECM Perform code registration (Immobiliser function)

  • Wireless door lock control system

  • Smart Entry and Start System (for Entry Function)

  • Smart Entry and Start System (for Start Function)

  • Steering lock function

 See Service Bulletin for the registration method.

Suspension, tires, etc.

(The vehicle height changes because of suspension or tire replacement)

 Rear television camera assembly optical axis (Back camera position setting) Parking assist monitor system

Click here for Initialization

Click here for Calibration
Perform headlight ECU sub-assembly LH initialization Lighting system (EXT) (w/ Automatic Headlight Beam Level Control System)

Click here

Front wheel alignment adjustment Perform system variant learning and acceleration sensor zero point calibration.

  • VSC disabled or malfunctioning

  • DTCs are output

  • Slip indicator light illuminated

  • ABS warning light illuminated

Click here

*1: When the ECM is replaced with a new one, reset memory is unnecessary.

Note

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE

    Click here

  2. REMOVE V-RIBBED BELT

    Click here

  3. REMOVE CRANKSHAFT PULLEY ASSEMBLY

    Click here

  4. REMOVE TIMING CHAIN COVER OIL SEAL


    1. B006XV4C01
      *a Protective Tape

      Using a screwdriver, pry out the timing chain cover oil seal.

      Note

      Do not damage the surface of the timing chain cover oil seal press fit hole or the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.