HEATED OXYGEN SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leak from exhaust system is repaired Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  4. REMOVE HEATED OXYGEN SENSOR (for Bank 2)


    1. B00707P

      Disconnect the heated oxygen sensor connector.

    2. Disengage the wire harness clamp.

    3. B006Y1FN01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00012

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.

  5. REMOVE BODY MOUNTING PLATE

    Click here

  6. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side)

    Click here

  7. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  8. REMOVE HEATED OXYGEN SENSOR (for Bank 1)


    1. B006YI8N01

      Using SST, remove the heated oxygen sensor from the front exhaust pipe assembly.

      SST
      09224-00012

      Note

      If the heated oxygen sensor has been struck or dropped, replace it.