IGNITION COIL AND SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE IGNITION COIL ASSEMBLY


    1. B0070WY

      Disconnect the 3 ignition coil assembly connectors.

    2. Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly LH.

      Note

      If an ignition coil assembly has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.

    3. B006XH6

      Disengage the 4 clamps to separate the vacuum hose from the intake air surge tank assembly.

    4. Disengage the 2 wire harness clamps.

    5. Disconnect the 3 ignition coil assembly connectors.

    6. B0071JY

      Remove the 3 bolts and 3 ignition coil assemblies from the cylinder head cover sub-assembly.

      Note

      If an ignition coil assembly has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.

  3. REMOVE SPARK PLUG

    Click here