CRANKSHAFT POSITION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during crankshaft position sensor removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Gas leak from exhaust system is repaired

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH (TWC: Front Catalyst)

    Click here

  2. REMOVE CRANKSHAFT POSITION SENSOR PROTECTOR


    1. B006YJ7

      Remove the 3 bolts and crankshaft position sensor protector from the cylinder block sub-assembly and oil pan sub-assembly.

  3. REMOVE CRANKSHAFT POSITION SENSOR


    1. B006YM7

      Disconnect the crankshaft position sensor connector.

    2. Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.

      Note

      If the crankshaft position sensor has been struck or dropped, replace it.