REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface.

      Note


      • Using height adjustment attachments and plate lift attachments, keep the engine assembly horizontal.

      • To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.

      • Using an engine sling device and engine lift, secure the engine assembly before servicing.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Keep the lip free from foreign matter.

      • Do not allow MP grease to contact the dust seal.

    3. B0070HIC01
      *a 0.35 to 0.55 mm

      Using SST and a hammer, tap in the rear engine oil seal.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )
      Standard Depth
      0.35 to 0.55 mm (0.0138 to 0.0217 in.) (From the edge of the cylinder block sub-assembly and stiffening crankcase assembly)

      Note

      Do not tap in the rear engine oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. B006XU7N01

      Using SST, hold the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. Clean the 8 bolts and bolt holes.

    3. B0071DB

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. B006XCRC01
      *1 Drive Plate And Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

      Note

      As the rear drive plate spacer and drive plate and ring gear sub-assembly are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    5. B006Y02C77
      *a Adhesive

      Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. B00709WN01

      Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note

      Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here