CAMSHAFT OIL CONTROL VALVE(for Exhaust Side of Bank 2) REMOVAL

PROCEDURE


  1. REMOVE FRONT WHEEL RH

    Click here

  2. REMOVE FRONT FENDER APRON SEAL RH

    Click here

  3. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  4. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 2)

    Click here

  5. SET NO. 1 CYLINDER TO TDC/COMPRESSION


    1. B00701AC01
      *a Timing Mark
      *b Timing Mark (Cutout)

      Turn the crankshaft pulley clockwise until its timing mark (cutout) is aligned with the timing mark on the timing chain cover assembly as shown in the illustration.

    2. B006YR9C03
      *a Correct
      *b Incorrect
      *c Cutout
      *d Up

      Check that the cutout of the camshaft timing gear assembly is at the top.

      Tech Tips

      If the cutout of the camshaft timing gear assembly is not at the top, turn the crankshaft 360° clockwise and align the timing mark (cutout) of the crankshaft pulley with the timing mark on the timing chain cover assembly again.

  6. REMOVE CAMSHAFT TIMING GEAR BOLT


    1. B006ZBQ

      While holding the crankshaft pulley, remove the camshaft timing gear bolt.

      Note


      • If the camshaft timing gear bolt has been struck or dropped, replace it.

      • Do not turn the crankshaft pulley after removing the camshaft timing gear bolt.