KNOCK SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. INSTALL KNOCK CONTROL SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the knock control sensor.

    Click here


    1. B006XVKC01
      *a Top
      *b Right of Vehicle
      *c 15°
      *d 5°

      Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

      Note


      • If the knock control sensor has been struck or dropped, replace it.

      • Make sure that the knock control sensor is in the correct position.

    2. Connect the knock control sensor connector.

  2. INSTALL GENERATOR ASSEMBLY

    Click here

  3. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the knock control sensor.

      Click here