Click here

ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here
Click here

PROCEDURE


  1. Click here

    DRAIN ENGINE COOLANT

    Click here

  2. Click here

    REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B0070ZF

      Disconnect the engine coolant temperature sensor connector.

    2. B006YUK

      Remove the clip and engine coolant temperature sensor from the water outlet.

      Note:

      If the engine coolant temperature sensor has been struck or dropped, replace it.