IGNITION COIL AND SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil assembly or spark plug removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here (w/ Canister Pump Module)

Click here (w/o Canister Pump Module)

Note

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  2. REMOVE IGNITION COIL ASSEMBLY


    1. B0070YB

      Disconnect the 4 ignition coil assembly connectors.

    2. Using an 8 mm socket wrench, remove the 4 bolts and 4 ignition coil assemblies from the cylinder head cover sub-assembly.

      Note

      If an ignition coil assembly has been struck or dropped, replace it.

      Tech Tips

      Arrange the removed parts in the correct order.

  3. REMOVE SPARK PLUG

    Click here