CRANKSHAFT POSITION SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

      Note

      If reusing the crankshaft position sensor, be sure to inspect the O-ring.

    2. Using an 8 mm socket wrench, install the crankshaft position sensor to the cylinder block sub-assembly with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note


      • If the crankshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the crankshaft position sensor.

    3. Connect the crankshaft position sensor connector.

  2. INSTALL STARTER ASSEMBLY

    Click here

  3. INSPECT FOR ENGINE OIL LEAK

    Click here