CAMSHAFT POSITION SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Note

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

PROCEDURE


  1. INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)


    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      Note

      If reusing the camshaft position sensor, be sure to inspect the O-ring.

    2. Using an 8 mm socket wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • If the camshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

    3. Connect the camshaft position sensor connector.

  2. INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)


    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

      Note

      If reusing the camshaft position sensor, be sure to inspect the O-ring.

    2. Using an 8 mm socket wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • If the camshaft position sensor has been struck or dropped, replace it.

      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.

    3. Connect the camshaft position sensor connector.

  3. INSPECT FOR ENGINE OIL LEAK

    Click here

  4. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here