AIR FUEL RATIO SENSOR(for Sensor 2) INSTALLATION

PROCEDURE


  1. INSTALL AIR FUEL RATIO SENSOR

    Tech Tips

    Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

    Click here


    1. B006Z4YC01
      *a Torque Wrench Fulcrum Length

      Using SST, install the air fuel ratio sensor to the front exhaust pipe assembly (TWC: Rear Catalyst).

      SST
      09224-00012
      Torque:
      Specified tightening torque
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

      Note

      If the air fuel ratio sensor has been struck or dropped, replace it.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)):

        37.7 N*m (384 kgf*cm, 28 ft.*lbf)

    2. Connect the air fuel ratio sensor connector.

    3. Engage the wire harness clamp.

  2. INSPECT FOR EXHAUST GAS LEAK

    Click here

  3. PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing the air fuel ratio sensor.

      Click here