ACTIVE CONTROL ENGINE MOUNT(for Rear Side) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Tech Tips

Refer to Problem Symptoms Table.

Click here

PROCEDURE


  1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

    Click here

  2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  5. INSPECT REAR ENGINE MOUNTING INSULATOR


    1. B006YBR

      Disengage the 2 clamps to separate the vacuum hose.

    2. Disconnect the vacuum hose.

    3. B006YEX

      Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.

    4. Check that there is no change in the needle movement of the vacuum pump gauge.

      OK
      Vacuum pressure holds.

    5. Check that there is no fluid leakage caused by a break in the diaphragm.

    6. Connect the vacuum hose.

    7. Engage the 2 clamps to install the vacuum hose.

  6. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  8. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  9. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

    Click here