ACTIVE CONTROL ENGINE MOUNT(for Front Side) ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

   Click here

2. Click here

   REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

   Click here

3. Click here

   REMOVE NO. 1 ENGINE UNDER COVER

   Click here

4. Click here

   REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

   Click here

5. Click here

   INSPECT FRONT ENGINE MOUNTING INSULATOR

   
   

   1. Disconnect the vacuum hose from the front engine mounting insulator.

   2. 

      Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.

   3. Check that there is no change in the needle movement of the vacuum pump gauge.

      OK
      Vacuum pressure holds.

   4. Check that there is no fluid leakage caused by a break in the diaphragm.

   5. Connect the vacuum hose to the front engine mounting insulator.

6. Click here

   INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

   Click here

7. Click here

   INSTALL NO. 1 ENGINE UNDER COVER

   Click here

8. Click here

   INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

   Click here

9. Click here

   INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

   Click here