SFI SYSTEM(w/o Canister Pump Module), Diagnostic DTC:P063051

DTC Code DTC Name
P063051 VIN Not Programmed

MONITOR DESCRIPTION

DTC P063051 is stored when the Vehicle Identification Number (VIN) or frame number is not stored in the ECM or the stored VIN or frame number is not accurate.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P063051 VIN Not Programmed

Either of the following conditions is met (1 trip detection logic):


  • The VIN or frame number is not stored in the ECM.

  • The VIN or frame number written to the ECM is not accurate.

  • VIN or frame number code

  • ECM

 Comes on DTC stored SAE Code: P0630

MONITOR STRATEGY

Required Sensors/Components ECM
Frequency of Operation Continuous

CONFIRMATION DRIVING PATTERN


  1. Connect the GTS to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the GTS on.

  4. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).

  5. Turn the ignition switch off and wait for at least 30 seconds.

  6. Turn the ignition switch to ON.

  7. Turn the GTS on.

  8. Wait 5 seconds or more.

  9. Enter the following menus: Powertrain / Engine / Trouble Codes.

  10. Read the pending DTCs.

    Tech Tips


    • If a pending DTC is output, the system is malfunctioning.

    • If a pending DTC is not output, perform the following procedure.

  11. Enter the following menus: Powertrain / Engine / Utility / All Readiness.

  12. Input the DTC: P063051.

  13. Check the DTC judgment result.

    GTS Display Description
    NORMAL

    • DTC judgment completed

    • System normal
    ABNORMAL

    • DTC judgment completed

    • System abnormal
    INCOMPLETE

    • DTC judgment not completed

    • Perform driving pattern after confirming DTC enabling conditions

    Tech Tips


    • If the judgment result is NORMAL, the system is normal.

    • If the judgment result is ABNORMAL, the system is malfunctioning.

CAUTION / NOTICE / HINT

Tech Tips

Read Freeze Frame Data using the GTS. The ECM records vehicle and driving condition information as Freeze Frame Data the moment a DTC is stored. When troubleshooting, Freeze Frame Data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P063051)


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Read the DTCs.


      Powertrain > Engine > Trouble Codes

      Note

      If P063051 is output, the VIN or frame number must be written to the ECM using the GTS. However, all DTCs are cleared automatically by the GTS when the VIN or frame number is written. If DTCs other than P063051 are output, troubleshoot them first.

      Result
      Result Proceed to
      DTC P063051 is output A
      DTC P063051 and other DTCs are output B

    B

    GO TO DTC CHART Click here

    A

  2. WRITE VIN OR FRAME NUMBER


    1. Write the VIN or frame number.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

    END