KNOCK SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the knock control sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of knock control sensor

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE INTAKE MANIFOLD

    Click here

  2. REMOVE KNOCK CONTROL SENSOR


    1. B004L14

      Disconnect the knock control sensor connector.

    2. Remove the bolt and knock control sensor from the cylinder block sub-assembly.

      Note

      If the knock control sensor has been struck or dropped, replace it.