Click here

ENGINE COOLANT TEMPERATURE SENSOR REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of engine coolant temperature sensor Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here
Click here

PROCEDURE


  1. Click here

    DRAIN ENGINE COOLANT

    Click here

  2. Click here

    REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. Click here

    REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

    Click here

  4. Click here

    REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. B006ZCY

      Disconnect the engine coolant temperature sensor connector.

    2. B007188N01

      Using SST, remove the engine coolant temperature sensor from the cylinder head sub-assembly.

      09817-33191
      Note:

      If the engine coolant temperature sensor has been struck or dropped, replace it.

    3. Remove the gasket from the engine coolant temperature sensor.