Click here

THROTTLE BODY REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Table 1. Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of throttle body with motor assembly

  • Cleaning the deposits from the throttle body with motor assembly

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here
Click here

PROCEDURE


  1. Click here

    DRAIN ENGINE COOLANT

    Click here

  2. Click here

    REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  3. Click here

    REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE


    1. B006XUY

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disengage the 2 wire harness clamps.

    3. B00710JC01
      *a Air Cleaner Cap Clamp
      *b Guide

      Disengage the 2 air cleaner cap clamps.

    4. Disengage the 2 guides to separate the air cleaner cap sub-assembly from the air cleaner case sub-assembly.

    5. B006YQ4

      Slide the clip and disconnect the ventilation hose from the cylinder head cover sub-assembly.

    6. B00712V

      Disengage the 2 clamps to separate the No. 2 fuel vapor feed hose assembly.

    7. B0071R3

      Loosen the hose clamp and remove the air cleaner cap with air cleaner hose from the throttle body with motor assembly.

  4. Click here

    REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. B0070NM

      Disengage the 2 clamps to separate the heater hose.

    2. B006ZFZ

      Disengage the clamp to disconnect the fuel tube sub-assembly from the fuel hose bracket.

    3. Remove the bolt and fuel hose bracket from the throttle body with motor assembly.

    4. B006ZC1C01
      *1 No. 1 Water By-pass Hose
      *2 No. 2 Water By-pass Hose

      Slide the 2 clips and disconnect the No. 1 water by-pass hose and No. 2 water by-pass hose from the throttle body with motor assembly.

    5. Disconnect the throttle body with motor assembly connector.

    6. B006ZLJ

      Remove the 4 bolts and throttle body with motor assembly from the intake manifold.

      Note:

      If the throttle body with motor assembly has been struck or dropped, replace it.

  5. Click here

    REMOVE THROTTLE BODY GASKET


    1. B006YRJ

      Remove the throttle body gasket from the intake manifold.