THROTTLE BODY ON-VEHICLE INSPECTION

PROCEDURE

1. Click here

   INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

   
   

   1. Check the idle speed.

      
      

      1. Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

         Standard
         610 to 710 rpm

         Note:
         

         • Be sure to perform this step with all accessories off.

         • Make sure that the shift lever is in P or N.

      2. Perform a road test and confirm that there are no abnormalities.

   2. Inspect the throttle position sensor.

      
      

      1. Connect the GTS to the DLC3.

      2. Start the engine.

      3. Turn the GTS on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / Throttle Sensor Volt %.

         
         
         1. Powertrain > Engine and ECT > Data List

            Tester Display
            Throttle Sensor Volt %

         2. 
            
            1. 
               
         3. 
            
            10. 
                

      5. According to the display on the GTS, read the Data List while fully depressing the accelerator pedal and check that the value is 60% or higher.

         If the value is less than 60%, check the throttle body with motor assembly, wire harness and ECM.