Click here

REAR TURN SIGNAL LIGHT BULB REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    REMOVE REAR COMBINATION LIGHT COVER

    Click here

  2. Click here

    SEPARATE REAR COMBINATION LIGHT ASSEMBLY


    1. B004HTBC01
      B006Y8C Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    2. B004K2Y

      Remove the 2 screws.

    3. B004HTPC01
      *a Pin
      *b Guide
      B006ZFL Separate in this Direction

      Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.

      Note:

      To prevent the rear combination light assembly from falling when disengaging the pin and guides, lightly hold the rear combination light assembly.

  3. Click here

    REMOVE REAR TURN SIGNAL LIGHT BULB


    1. B004IWLC01
      B006ZFL Disconnect in this Direction

      Turn the rear combination light socket and wire with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

    2. Remove the rear turn signal light bulb from the rear combination light socket and wire.