A25A-FKS DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL V-RIBBED BELT

    Tech Tips

    When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.


    1. B007128C03
      *1 Crankshaft Pulley Assembly
      *2 Generator Assembly
      *3 Compressor Assembly With Pulley

      Set the V-ribbed belt onto each pulley as shown in the illustration.

    2. Turn the V-ribbed belt tensioner assembly clockwise and remove the 5 mm hexagon wrench.

    3. B006YD9C01
      *a Correct
      *b Incorrect

      After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the V-ribbed belt has not slipped out of the grooves on the bottom of the pulley by hand.

  2. INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

    Click here

  3. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  4. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

    Click here

  5. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH

    Click here