Click here

A25A-FKS SPARK PLUG REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.

Table 1. Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of ignition coil assembly

  • Replacement of spark plug

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here(w/ Canister Pump Module)

Click here(w/o Canister Pump Module)
Note:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click here

Click here

PROCEDURE


  1. Click here

    REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  2. Click here

    REMOVE IGNITION COIL ASSEMBLY

    Click here

  3. Click here

    REMOVE SPARK PLUG


    1. B006WRY

      Remove the 4 spark plugs from the cylinder head sub-assembly.

      Note:

      If a spark plug has been struck or dropped, replace it.

      Tip:

      Arrange the removed parts in the correct order.