AUTOMATIC TRANSAXLE FLUID REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the automatic transaxle fluid replacement are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of automatic transaxle fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly.

Click here

PROCEDURE


  1. REMOVE FRONT FENDER APRON SEAL LH

    Click here

  2. REPLACE AUTOMATIC TRANSAXLE FLUID

    Click here

  3. ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID

    Click here

  4. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the GTS)

    Click here

  5. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the GTS)

    Click here

  6. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL

    Click here

  7. REBUILD WORK

    Click here

  8. INSTALL FRONT FENDER APRON SEAL LH

    Click here

  9. ATF THERMAL DEGRADATION ESTIMATE RESET

    Note

    Perform ATF Thermal Degradation Estimate Reset if approximately 50% or more of the ATF has been replaced during a repair or a similar operation.

    Click here