AUTOMATIC TRANSAXLE SYSTEM MANUAL SHIFTING TEST


  1. PERFORM MANUAL SHIFTING TEST

    Tech Tips


    • Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

    • If any abnormalities are found in the following test, the problem is in the transaxle itself.


    1. B004M68

      Disconnect the wiring harness connector connector.

      Tech Tips

      It is possible to deactivate the electrical shift control by disconnecting the wiring harness connector connector. The gears can then be changed mechanically with the shift lever.

    2. Drive the vehicle with the wiring harness connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

      Shift Lever Position Gear
      P P
      R R
      D

      3rd

      No Shift (Gear will not change)

    3. Connect the wiring harness connector connector.

    4. Clear the DTCs.


      Powertrain > Engine and ECT > Clear DTCs